Setting up the Bagpipe Cradle - Safety Cautions!

When your Bagpipe Cradle arrives, it should be very evident on how it assembles.

No bolting, screwing or inserting of nuts/bolts is need. Fact, no tools are required other than a knife to open the box.

Note! - Setting up your stand legs like this will ABSOLUTELY make your stand tip or even fall !

Simple steps:

1. Un-pack both the wood cradle and stand.
   
2. Set the tripod stand legs to full extention, cross bars are almost pararell with the floor (see photo A)
   
3. Tighten lower knob - hand tight is good (photo B)
   
4. On the pole, loosen the knob and raise the internal pole a inch or two, then tighten knob.
   
5. Attach the wood cradle to the pole and tighten knob on wood cradle bracket.
   
6. Your done!
   

There is no adjusting the angle of the wood cradle.  It is set around 60-65 degrees for balance

Alignment - Please keep the front of the wood cradle inline with one leg (as shown)

You will notice that the knobs will all face to the back when aligned right!

Photo A

Photo B